| Internet-Draft | SAV-D | September 2023 |
| Cui, et al. | Expires 15 March 2024 | [Page] |
Existing SAV schemes can not effectively defend against IP Spoofing DDoS under incremental deployment. This document proposes SAV-D, a savnet based distributed defense architecture to enhance SAV's defense. The main idea of SAV-D is to collect and aggregate more threat data from existing SAV devices and then distribute crucial knowledge to widespread devices, thus significantly expanding defense across the entire network.¶
This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.¶
Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.¶
Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."¶
This Internet-Draft will expire on 15 March 2024.¶
Copyright (c) 2023 IETF Trust and the persons identified as the document authors. All rights reserved.¶
This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License.¶
Distributed Denial-of-Service (DDoS) attacks have been a persistent cyber threat, where IP spoofing DDoS is one of the major contributors. Amplification DDoS typically exploit IP spoofing to generate large volumes of traffic with small requests, allowing attackers to overwhelm the target's resources while evading detection. Some other DDoS attacks (e.g., TCP SYN Flooding [RFC4987]) also forge source IP addresses in order to drain the target's resources.¶
To eliminate IP spoofing, several Source Address Validation (SAV) schemes have been proposed, such as SAVI[RFC7039], uRPF[RFC3704] and EFP-uRPF[RFC8704]. However, the defense effectiveness of current SAV schemes highly depends on the SAV devices' deployment ratio. A large number of spoofed packets can only be prevented with a significantly high deployment ratio, but the incremental deployment process is often slow. According to CAIDA's Spoofer Project[CAIDA], 24.9% of IPv4 autonomous systems (excluding NAT), and 33.3% of IPv6 autonomous systems are still spoofable by March 2023. This indicates a limited SAV deployment, thus the defense effectiveness.¶
In the above context, this document offers an SAV-based anti-DDoS architecture (SAV-D) that incorporates the following advances.¶
Through the mechanisms of honeynet, data aggregation and distribution, SV-D can fully leverage the value of SAV devices and threat data, resulting in a significant defense improvement.¶
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here.¶
The effectiveness of existing SAV schemes highly relies on the deployment ratio of devices, which is currently limited. Adversaries often actively test their bots for plausibility, packet loss, and amplification benefits. This testing can force the bots to migrate from SAV domains to non-SAV domains, resulting in fewer spoofed packets being blocked by SAV devices. Additionally, uRPF and EFP-uRPF have issues with filtering accuracy in certain scenarios. Some managers may hesitate to enable SAV due to the probability of filtering errors. Moreover, SAV can prevent spoofed packets from being sent out, but it cannot provide protection for the deployers. The lack of direct benefits may also impede the deployment process. In this context, there is a strong need to improve the defense capabilities of current SAV practices.¶
To achieve the goal, it is essential to consider the following limitations. Firstly, due to the attack testing, directly dropping spoofed packets can reduce the possibility of capturing threat data. Secondly, in amplification DDoS, the reflected packets sent to victims have the authentic src-IP, making them unfilterable by SAV devices. Lastly, although today's SAV mechanism can filter spoofed packets at local devices, the important threat information they provide has yet to be fully utilized. If victims were made aware of the type of spoofing traffic targeting them, they could execute faster and more accurate countermeasures.¶
+------------------------------------------------------------+
| Control Plane (SAV Controller) |
+------------------------------------------------------------+
| +--------------+ +----------------+ +--------------+ |
| |Detecting DDoS| |Generating Rules| |Issuing Rules | |
| +--------------+ +----------------+ +--------------+ |
| -\ -\ |
| -/ -/ |
| +----------------+ +--------------+ |
| | Maintain IP | |Sharing Threat| |
| | Blocklists | |Information | |
| +----------------+ +--------------+ ... |
+---------/\-------------------------------------++----------+
|| +-------------------+|
|| |+------------------+|
|| || ||
+---------++-----------------\/--+ +-------------\/----------+
| Data Plane | | Data Plane (Legacy |
| (SAV Devices) | |Devices,Victims' Defense)|
+--------------------------------+ +-------------------------+
| +----------+ +---------------+ | | +---------------+ |
| |Monitoring| | Filtering | | | | Filtering | |
| +----------+ +---------------+ | | +---------------+ |
| +---------------+ | | +---------------+ |
| |Receiving Rules| | | |Receiving Rules| |
| +---------------+ | | +---------------+ |
| ... | | ... |
+--------------------------------+ +-------------------------+
Figure 1: The SAV-based Anti-DDoS Architecture
¶
The proposed SAV-D is shown in Figure 1, whitch can be deployed on both intra-domain and inter-domain savnet. It introduces a centralized control plane (i.e., the controller) that connects SAV devices, legacy devices, and victims' defense systems. The functions of the controller can be divided into three parts: attack detection, analysis and defense execution. The controllers can collect spoofing characteristics from widespread SAV devices (as honeypots) and aggregate them for further analysis. From a whole viewpoint, the controller can detect ongoing attacks and generate filtering rules for both SAV and non-SAV devices. In addition, the controller can maintain IP blocklists based on the information reported by SAV devices, whitch can assist in detectiong DDoS attacks and generating filtering rules. And then the rules will be distributed to corresponding devices to perform filtering. Moreover, the controller will share the attack information with the victims' defense system to assist in their defense operations.¶
The controller is a logical entity that can be implemented as a distributed or centralized cluster system. The placement of controllers may take several factors into consideration, including latency, resiliency, and load balancing to connected devices.¶
The SAV devices refer to routers or switches that are capable of validating the source IP address, including SAVI, uRPF, etc. Compared to simply dropping spoofed packets, SAV devices are required to selectively allow spoofed packets through if they do not match the filtering rules. This mechanism can be considered as a SAV-honeynet that records threat data related to spoofing.¶
The commercial routers that are widely deployed in production are considered to be legacy devices. Access Control List (ACL) is universally supported in today's routers for packet filtering. Legacy devices can achieve extensive filtering by simply connecting their management interface to the controller and receiving the rules. Since ACLs may vary across legacy devices, filtering rules must be adapted to meet the specific requirements of each device. The legacy routers can join the SAV-D system by registering it to the controller with information similar to the SAV router. Once registered, the legacy routers can receive the filtering rules from the controller in a safe and trusted channel. These rules will be installed into the data plane. Similar to SAV devices, if a rule filters no packet during some period, the rule will be automatically removed.¶
The SAV deployers can request access to the attack detection information related to themselves. The information includes various details such as the attack target, type, duration, and malicious IP lists. These details can serve as auxiliary signals to boost the detection time. In addition, SAV-D can provide real-time updated IP blocklists, which can be efficiently used for blocking malicious traffic. In an ideal situation, the defense system could provide an interface to directly receive the information and automatically perform corresponding filtering policies. This mechanism could improve the effectiveness of DDoS defense and incentivize more SAV deployment.¶
+-------------------------------+
+-------+ | +-------+ +-------+ | +-------+
| SR 1 +---+ | SC 1 +----+----+ SC 2 | +--+ SR 3 |
+-------+ | +-------+ | +-------+ | +-------+
| | |
+-------+ | +---+---+ | +-------+
| SR 2 +---+ | SC 3 | +--+ SR 4 |
+-------+ | +-------+ | +-------+
+-------------------------------+
SR: SAV router
SC: SAV controller
Figure 2: Connection Example of SAV Devices
¶
Figure 2 depicts a connection example of SAV-D system. There are SAV routers distributed throughout the network, and they MUST communicate with the SAV controller in order to collaborate. This document suggests that each SAV router stores several records of the SAV controller for backup. Each SAV router MUST try to connect to its nearest SAV controller at all times. If the SAV router loses contact with the present controller, it MUST seek the next closest controller. Such a mechanism can assist SAV routers in maintaining connections to the best of their abilities.¶
The SAV controller appears as a single entity to the external. Realizing the full functionality of the SAV controller MAY require many computing and storage resources. As a result, the SAV controller can be built as clustered or distributed servers, where consistency and scalability are the primary concerns. Each SAV controller can communicate with many SAV routers and perform the corresponding functions.¶
Data transmission includes bidirectional data transmission of control plane and data plane. The monitoring information of the spoofed src-IP packets is transmitted from the data plane to the control plane. Following the existing definition of savnet, the monitoring information transmission protocol should follow YANG Data Model for Intra-domain and Inter-domain Source Address Validation. In the opposite direction, the filtering rules and threat information are transmitted. The transmission of filtering instructions can be referred to DOTS Telemetry[RFC8783], whitch describes the transmission requirements of collaborative filtering instructions. The threat information includes the attack detection resultant, victim IP ddress segmant and etc. [RFC9244] and [RFC8783] describe the transmission requirements for threat information, whitch can be the candidate protocol.¶
The proposed SAV-D architecture can collaboratively defend the IP spoofing DDoS in a distributed pattern. The typical procedures are described as follows.¶
(i). The SAV routers validate and record the characteristics of spoofed packets, and periodically send this data to the logically centralized controller, where the global spoofing information is aggregated.¶
(ii). Based on the aggregated statistics, the controller can accurately detect whether there are ongoing IP spoofing attacks with the help of predefined algorithms.¶
(iii). Based on the detection results, the controller can generate defense policies for both SAV and non-SAV devices. The policies mainly involve filtering rules on 5-tuple and packet size.¶
(iv). For detected attacks, the defense policies will be distributed to all SAV and legacy devices. Moreover, the detection results will also be sent to the victim's defense system.¶
(v). The filtering rules will be installed on relevant devices to block the malicious packets. If a rule filters no packet during some period, the rule will be automatically removed.¶
When there are large amounts of devices introduced into the SAV-D, the control plane could be implemented with hierarchical structure, where multiple sub-level controllers are in charge of the devices inside AS domains. The single top-level controller can exchange information (i.e., IP spoofing statistics and filtering rules) with these sub-level controllers. Additionally, a large number of attacks and filtering rules could introduce another scalability problem. One possible solution is to prioritize the mitigations of these attacks, where severe attacks will be tackled first so that the number of filtering rules will be limited to moderate scope.¶
This document includes no request to IANA.¶
Adversaries may send forged IP spoofing statistics to the control plane or send forged filtering rules to SAV and legacy devices, which could cause severe harm to legitimate traffic. To avoid this situation, the information transmissions of SAV-D could be encrypted with certification. There could also be attacks directly on the SAV-D controllers. As common systems, security systems (e.g., firewalls) are essential to protect the controllers. In addition, hot-standby controllers can also significantly improve security and availability.¶
Thanks to Linbo Hui, Yannan Hu, Wenyong Wang for their contribution to this draft.¶